atg v3 - AllMYRC.com-A Radio Control Helicopter, Airplane and Car Community

blingboy · 04-17-2010, 01:56 AM

i have an atg v3 and in normal mode when gov is turned off i get a red light when the sensor picks up the magnet but in idle up 1 and 2 , i get the green solid light is that how its supposed to be or should the red light flash when the magnet passes the sensor in gov on mode ....just want to make sure i have it set up right before going to the field and chasing a problem all day .

Any help would be much appreciated

helivig · 04-17-2010, 10:06 PM

It sounds correct.

blingboy · 04-17-2010, 11:21 PM

thanks so much just another quick question , when i do the high and low throttle settings in the atg the low throttle sets as a high number and the high throttle sets as a lower number in the set up , but it the pictures of the g view in the instruction the high throttle has the high number and the low throttle has the low number does this matter at all ??

04-17-2010, 01:56 AM	#1 (permalink)
blingboy AllMYRC Newbie Join Date: Mar 2010 Posts: 4	atg v3 i have an atg v3 and in normal mode when gov is turned off i get a red light when the sensor picks up the magnet but in idle up 1 and 2 , i get the green solid light is that how its supposed to be or should the red light flash when the magnet passes the sensor in gov on mode ....just want to make sure i have it set up right before going to the field and chasing a problem all day . Any help would be much appreciated

04-17-2010, 10:06 PM	#2 (permalink)
helivig AllMYRC Member Join Date: Jul 2009 Posts: 381 Blog Entries: 256	It sounds correct. __________________ Curtis Youngblood curtisyoungblood.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-17-2010, 11:21 PM	#3 (permalink)
blingboy AllMYRC Newbie Join Date: Mar 2010 Posts: 4	thanks so much just another quick question , when i do the high and low throttle settings in the atg the low throttle sets as a high number and the high throttle sets as a lower number in the set up , but it the pictures of the g view in the instruction the high throttle has the high number and the low throttle has the low number does this matter at all ??